Chlorine Dioxide Generator - SafeOx 614
The SafeOx 614 chlorine
dioxide generator comprises a simple panel-mounted, two-part
generating system that uses sodium chlorite and hydrochloric acid
in the presence of a unique catalyst to generate significantly greater
levels of ClO2 than traditional production methods. Each SafeOx
generating system is built to the highest manufacturing standards,
and is designed for continuous operation in sterilisation units,
cooling towers and other industrial and commercial applications.
Chlorine Dioxide Per Day
The SafeOx 614 system will generate up to 0.614 Kg (1.35 pounds)
of chlorine dioxide per day.
Catalyst Column
This generator system operates in conjunction with the SafeOx RC
614 catalyst column.
Precursor Specifications
- SafeOx approved sodium chlorite solution.
- SafeOx approved hydrochloric acid.
- SafeOx catalytic reactor.
Important Notice: The use of precursors other than those specified
by SafeOx and operating outside the recommended parameters invalidates
any warranty given with this equipment.
Feed Water
The feed water must be potable or equivalent. It cannot be chemically
treated process or cooling water. Additives or contaminants not
approved at potable levels will affect the performance of the system
and purity of the chlorine dioxide product. Performance, efficiency
and lifespan are partly determined by the physical and chemical
characteristics of the water. SafeOx assumes that the following
specifications have been met.
Temperature - The allowable feed water temperature
range is 41 to 95 °F (5 to 35 ºC). If the feed water
temperature is not within specification, a simple heat exchanger
(coiled copper tubing, heat tape, etc.) may be useful.
Pressure - A minimum feed water pressure of
30 psi (2.04 bar) is required. A pressure-reducing valve on the
system may be used to lower incoming pressure. Avoid feeding the
system from make-up lines with frequent pressure drops and fluctuations.
Product Delivery - These SafeOx systems will
dose into pressurised lines up to 20 psi maximum. For dosing into
lines above 20 psi, a SafeOx Dosing Package is required.
Environmental Conditions - Avoid locations where
the systems will be subjected to extreme cold or heat, i.e., below
5 °C (41 °F) or above 45 °C (614 °F), direct sunlight,
vibration, vapours, liquid spills or EMI (electromagnetic interference
i.e. strong radio transmission and electric motors). The systems
could be damaged which will invalidate the warranty.
Electrical - The systems must be wired in accordance
with all applicable electrical codes. These SafeOx units are fuse
protected (replaceable plug-in 5 amp fuse on the relay board)
and single voltage 115 VAC, 5 Amperes, 60 Hz. The systems can
operate at 50 Hz with a ~16 % loss in pump efficiency. The output
relays are also individually fuse protected. Use of a surge protector
is recommended.
Physical Specifications of SafeOx Generators
- Dimensions - 91 cm X 61 cm X 20 cm (36 inch X 24 inch X 8
inch).
- Weight (operational) - 27 kg (60 pounds).
- Pumps (2) - MasterFlex® peristaltic with Norpreneä
tubing.
- Reactor - A specially designed reactor allows for optimum
reaction efficiency of the chlorite-acid solution rite-acid
solution.
- Electrical Source - 115 or 230 volt, 60 Hz (50 Hz with a ~16
% loss in pump efficiency).
- Solenoid Valve - Direct action, 2-way solenoid valve protects
the system during non-service operation.
- Flow Switch - This switch shuts down the two pumps if a flow
loss is detected.
- Flow Controller - This device maintains a constant flow rate
from 25 to 100 psi (1.72 to 6.9 bar).
- Remote On/Off - Two terminal blocks are provided. Connecting
a 120 VAC rated contact will provide remote operation. Close
contact to operate.
- ClO2 Flow Rate - Approximately 160 ml/min.
- ClO2 Concentration - Approximately 380 ppm.
- Efficiency - 85% or more.
Important Notice: It is the responsibility of the
SafeOx operator to properly apply the chlorine dioxide and to understand
the relevant local and international regulations concerning the
use of chlorine dioxide.
Additional Information
For more information about SafeOx products please call us on +44
(0) 161 877 2334 or e-mail info@safeox.com.
Back to top
|
